Rob Flinn
Well-known member
I'm just starting assembly of my C12 clone & thought it might be interesting to share some pictures.
I was lucky that Laurent (Group member pyjamaman), was kind enough to supply me with a piece of brass tube that was the perfect fit inside the outer tube. Getting this tube enabled my cousins husband Keith to turn some other case components for me. Volker also helped me obtain some of the high value resistors from mouser.
I'm going to try using a modified Tbone PSU from a mic I used as a donor for another project. After changing a couple of zeners it seems to be perfect for the job. The original safety earthing looked rather dangerous, & I replaced that. The case earth being a rather thin wire that connected to the regulator PCB & from there to the case !!!!
Capsule is courtesy of Tim Campbell, & o/p transformer from AMI.
I was lucky that Laurent (Group member pyjamaman), was kind enough to supply me with a piece of brass tube that was the perfect fit inside the outer tube. Getting this tube enabled my cousins husband Keith to turn some other case components for me. Volker also helped me obtain some of the high value resistors from mouser.
I'm going to try using a modified Tbone PSU from a mic I used as a donor for another project. After changing a couple of zeners it seems to be perfect for the job. The original safety earthing looked rather dangerous, & I replaced that. The case earth being a rather thin wire that connected to the regulator PCB & from there to the case !!!!
Capsule is courtesy of Tim Campbell, & o/p transformer from AMI.