tardishead
Well-known member
Yes I know very decadent and inefficient but what are the dos and don'ts in this topic.
My friend has some awesome old SE tube amps 10 watts. I was wondering if I could push the output tubes and use the units for processing line level signals.
So it needs some kind of power soak. How about simulating a speaker with a 10 watt 4 ohm shunt resistor and then parallel another pad for line level tap????
I had posted about building a 2a3 mic preamp but the overall response was not worth it. I was thinking padding down the output of tube amps might be an easier way of getting the colour from these old tubes at different levels of drive.
My friend has some awesome old SE tube amps 10 watts. I was wondering if I could push the output tubes and use the units for processing line level signals.
So it needs some kind of power soak. How about simulating a speaker with a 10 watt 4 ohm shunt resistor and then parallel another pad for line level tap????
I had posted about building a 2a3 mic preamp but the overall response was not worth it. I was thinking padding down the output of tube amps might be an easier way of getting the colour from these old tubes at different levels of drive.