WTB Class A Output Driver PCB, CANIL or?

[nielsk]

Trying to finish a project and I ran out of the CANIL Class A Driver (rev2) PCBs I had from long ago, and I have not been able to find someone who will make a few from the PDF I have of it, nor the time to re-create from scratch.
This is simply the output driver (everything past the fader pot) from a Neve BA283 / 183 card, on a small square PCB, so there may be other versions out there that would work.
If anyone out there has some they never used...

Thanks!

 

[mylesgm]

I think I have a few. I can’t check till feb thoigh, if you haven’t found any before then message me and I’ll look.

 

[nielsk]

Roger that, thanks!

 

[dmp]

Can you post a picture of one? I might have some

 

[nielsk]

Here you go!
There was also a PCB of the entire BA283 using a TIP3055, which I could make work.
(I do prefer the more traditional form factor of this one with room for the TO-3 heatsink and to not waste the 1st section)
I know other PCBs have been made of the same thing, and could work as well, so I am open to whatever will work

 

[dmp]

Yes, that's a familiar board. I had some at one time. I'll look around

 

[nielsk]

Thanks!