Hi,
I've a Digidesign 888/24 that keeps cutting out mid session.
Its chained off a 192.
If i turn it off and on again and restart protools its is fine for another hour or two and then it cuts out again.
any ideas?
could it be overheating or losing sync?
We have another 888 which is fine so i don't think its a sync problem.
I've a free U on top and below now and its still doing it.
ta
paul
I've a Digidesign 888/24 that keeps cutting out mid session.
Its chained off a 192.
If i turn it off and on again and restart protools its is fine for another hour or two and then it cuts out again.
any ideas?
could it be overheating or losing sync?
We have another 888 which is fine so i don't think its a sync problem.
I've a free U on top and below now and its still doing it.
ta
paul