- Joined
- May 3, 2018
- Messages
- 29
OK Im super fresh, FYI.
I recently bought a set of Troodent PCB's and Im starting to get everything figured out before I go to my local (Amazing) electronics supply store. I would really like to add an output adjustment of some sort so I could drive this preamp before going into my converters. This seems like it would be super simple, I just am lost as to the best place to put it. Would I just put a pot in across one of the XLR pins? That seems too easy/ would color the sound, right? Again I'm super fresh, so I apologize.
The only other thing Im up in the air on this thing is whether I should add a PPM meter instead of just the peak meter. I realize this would be adding a circuit, and I haven't researched that too well yet.
I attached the schematic for reference to what Im working on.
I recently bought a set of Troodent PCB's and Im starting to get everything figured out before I go to my local (Amazing) electronics supply store. I would really like to add an output adjustment of some sort so I could drive this preamp before going into my converters. This seems like it would be super simple, I just am lost as to the best place to put it. Would I just put a pot in across one of the XLR pins? That seems too easy/ would color the sound, right? Again I'm super fresh, so I apologize.
The only other thing Im up in the air on this thing is whether I should add a PPM meter instead of just the peak meter. I realize this would be adding a circuit, and I haven't researched that too well yet.
I attached the schematic for reference to what Im working on.