clintrubber
Well-known member
So they drilled some hole in the back I understand?
As an alternative/easier:
there's also this type as I mentioned above, with rear-screwdriver-slot (attached pic).
This transfers the mechanical job to the shaping of the shaft of the rear-pot.
Another alternative, if possible, is to find alike pots (one with motor, but wrong value, - the other with the desired value)
and swap the resistive sections.
As an alternative/easier:
there's also this type as I mentioned above, with rear-screwdriver-slot (attached pic).
This transfers the mechanical job to the shaping of the shaft of the rear-pot.
Another alternative, if possible, is to find alike pots (one with motor, but wrong value, - the other with the desired value)
and swap the resistive sections.