Rybow
Well-known member
Ok. So if I jumper my 75101 in series for 600ohms on the primary, I will have a 1:5 ratio. A 25k resistor will give me a 1K impedance on the primary. So, is this in addition to the transformers impedance? If I left the load out, would the primary impedance be just 600 ohms? Transformers are one thing I still don't fully understand.
Is 1k the optimal impedance? It seems to me that messing around with the load resistor gives you different impedance matching values for different mics. You could throw a couple resistors on a switch and then be able to change impedance depending on the mic. Not that I want to, just trying to understand.
Thanks for all your help! I'll get to reading this thread again.
Is 1k the optimal impedance? It seems to me that messing around with the load resistor gives you different impedance matching values for different mics. You could throw a couple resistors on a switch and then be able to change impedance depending on the mic. Not that I want to, just trying to understand.
Thanks for all your help! I'll get to reading this thread again.