JamieOxford
Member
- Joined
- May 7, 2017
- Messages
- 24
I'm looking to modify a Boss DM-2 so I can use it as pre-delay unit.
This should be a fairly simple job - just to install a switch that cuts the dry signal.. But I'm unsure of where in the circuit to install the switch without interrupting the rest of the pedal.
On the schematic attached I've added a couple of potential points in the bottom left. Is this possible or will it upset the op-amp IC1 ?
Thanks!
Jamie
This should be a fairly simple job - just to install a switch that cuts the dry signal.. But I'm unsure of where in the circuit to install the switch without interrupting the rest of the pedal.
On the schematic attached I've added a couple of potential points in the bottom left. Is this possible or will it upset the op-amp IC1 ?
Thanks!
Jamie