Hi All!
I'm about to complete stufing my last mixer prototype, and as a prototype i need to use sockets to try different opamps.
I ordered mc33078, ne5532, lm4562, and line drivers and receivers... (DIP8), surrounded by smd caps and melf resistors...
As the bandwidth of all the audio stages is limited to below 100khz, i would like to know if i should worry too much about socket pin inductance... or how can i measure it with a scope..
thank you for your advise!
JAY X
I'm about to complete stufing my last mixer prototype, and as a prototype i need to use sockets to try different opamps.
I ordered mc33078, ne5532, lm4562, and line drivers and receivers... (DIP8), surrounded by smd caps and melf resistors...
As the bandwidth of all the audio stages is limited to below 100khz, i would like to know if i should worry too much about socket pin inductance... or how can i measure it with a scope..
thank you for your advise!
JAY X