[quote author="uk03878"]Purusha - nice build - might want to move that transformer hook up cable away from transistor heat sinks (can you hook it under the output board?)[/quote]
No worries, transistors are far from being hot :thumb:
[quote author="radiance"]Nice build :thumb: Did you use Steffens schematic?[/quote]
I went P2P based on Franks PCB layout and partially home made PCBs for the high boost... but it didn't
work right although it was done exactly as Frank's PCB. It was funny as Sintech got the same results
with P2P but Franks Pultec seems to work just fine.
At the end I redrawn Gyraf's Pultec schematics to suite my choice of caps and inductors and then it worked nicely :wink:
[quote author="CJ"]purusha, you made that box your bitch, man! [/quote]
Yeah, I am very happy about it! Thanks for the help around the input iron wiring :thumb:
[quote author="barclaycon"]Very nice work. I hadn't realised that Pultec used a tapped inductor.
Has that been the subject of some discussion around here?
Also where did ytou get the inductor from ?[/quote]
The multitapped inductors came from Neeno :thumb: Like half the cost compared to the Sowters custom version.
tap dc ohms Q
1 26mh 20.6 7 1/2
2 39mh 25.8 9 1/4
3 78.8mh 37.9 13
4 155mh 55.8 18
5 312mh 84.1 25