Hi All
I am working on building a small pcb for a 3 band guitar eq. I am using the schematic of someone from a guitar forum, the Phabbtone EQ. I have adjusted his schematic a bit, and I have put the schematic in Eagle. But then it takes me ages to turn it into a board in Eagle. At one point, I had a nice layout, and after that, the making the actual pcb with photosensitive boards and a light unit is pretty easy. But I had made a mistake and now it is taking me hours again to get it into a board. Are there any rules of thumbs or guidelines to make this process a bit easier? Or is it just a matter of keeping on trying?
Cheers
Erik
PS this is the schematic, not that difficult I would say:
I am working on building a small pcb for a 3 band guitar eq. I am using the schematic of someone from a guitar forum, the Phabbtone EQ. I have adjusted his schematic a bit, and I have put the schematic in Eagle. But then it takes me ages to turn it into a board in Eagle. At one point, I had a nice layout, and after that, the making the actual pcb with photosensitive boards and a light unit is pretty easy. But I had made a mistake and now it is taking me hours again to get it into a board. Are there any rules of thumbs or guidelines to make this process a bit easier? Or is it just a matter of keeping on trying?
Cheers
Erik
PS this is the schematic, not that difficult I would say: