i noticed as i was about to stuff the ratio switch (lorlin rotary) into the pcb that mouser sent me a 2 pole/6 position switch instead of a 2 pole/4 position.
my first question is, if i go ahead and install the 6 position switch, will the existing ration selections fall on the first four positions...or will the switch not work at all?
my second question is, if it will work, is there an easy way to wire the 5th or 6th position for the four-buttons-in "slam" mode? if so, i'd love to use this switch instead of wiring a front panel switch...and it might be nice to have one position left open for a future mod of some sort...perhaps an additional ratio choice.
this is my first DIY project, so i'm sorry if the answers to these questions are simple and i'm just not seeing them.
thanks,
adam
my first question is, if i go ahead and install the 6 position switch, will the existing ration selections fall on the first four positions...or will the switch not work at all?
my second question is, if it will work, is there an easy way to wire the 5th or 6th position for the four-buttons-in "slam" mode? if so, i'd love to use this switch instead of wiring a front panel switch...and it might be nice to have one position left open for a future mod of some sort...perhaps an additional ratio choice.
this is my first DIY project, so i'm sorry if the answers to these questions are simple and i'm just not seeing them.
thanks,
adam