Actually the component designations were sequentially inserted by the PCB design software, so I wasnt really paying attention to them... the VALUES are all clear as day, so it should be impossible to wrongly insert a component.
Yes C1 and C5 are both 100p.
-This was my first ever layout attempt in Eagle by the way, so I'm not used to it yet, and haven't figured out how to move component designations, otherwise all of this would have been tidies, but I did look at it and conclude that it sould be impossible to put the wrong resistor in the wrong hole, based on the fact that their values are absolutely unambiguous.
please notice that the connections are neatly arranged along one edge, and that there are ten of them. When it's tested, I'll be posting a BOM, a connection list for the ten wires, some photos and some video of how it differs in the two modes, together with an in-shot comparison of an actual SSL console bus compressor, for direct side-by-side comparison.
Keith