HellfireStudios
Well-known member
The break will do you you some good. Sometimes I wait for up to a week before I retackle a project. The situation is similar to the ear fatigue you can experience when mixing for too long...
-James-
-James-
Rossi said:In my experience, reversing D and S makes almost no difference. I do have a look at the datasheet every time I use a new FET type. Also, there some FETs (e.g. BF types) that do not have the gate in center position.
gary o said:... but put source & gate round the other way ...... got same measurements kinda supprting that it may not matter which way round gate & source are.... but can that really be true....why have a gate & a source if so ..... but yeah in my circuit it didnt seem to make a difference ......
And now the gate might not be middle leg nooooo .....
I had two packeds of FETS that I have lost track of where they came from ....
MatthisD said:Are you sure C6 is causing a problem? without C6, R8 and R5 is a 20M resistor. If you have the right values of 10M/100nF then I can't see how it would drop the gain. You can't properly read the capsule voltage there with a meter because of the volts dropped across 20Meg of resistance once the meter probe makes contact. Tip your probe there for a split second and see what your meter reads.
micaddict said:KM74?
micaddict said:Neumann KM74 was the precursor of the K84.
Unlike the KM54 and KM64, it did not have a tube, but it still did have a PSU.
Enter your email address to join: