Proper microphone "body" parts naming conventions

[komikuapples]

The main issue I've been facing is to find the proper names for things like the PCB mount on the inside, or the outer tube. Is there a proper naming convention or reference document that shows the “industry standard” names for these parts, assuming that exists?
I apologize if this is an astronomically dumb question, I was unable to find a naming guide myself.

 

[soapfoot]

"Headbasket" is correct

What you call frame/board mount I've often seen called "side rails" (but not every mic body is built this way, obviously).

What you've called "tube/shell" I've seen referred to as "body tube"

 

[Delta Sigma]

Endcap = Bottom Bell?