Rode K2/NTK 1 R resistor value

[Jakub W]

Hey everyone. I am fixing my broker Rode NTK and found 2 faults. The high voltage capacitors were dead and the R1 resistor in the mic, right after the capsule blew up. I found 2 schematics. In one there is a given value of 3 G (gigaohms?!) and the other is just statung „high value”. Any advice on determining the correct value will be much appreciated.

 

[kingkorg]

Hey everyone. I am fixing my broker Rode NTK and found 2 faults. The high voltage capacitors were dead and the R1 resistor in the mic, right after the capsule blew up. I found 2 schematics. In one there is a given value of 3 G (gigaohms?!) and the other is just statung „high value”. Any advice on determining the correct value will be much appreciated.

3Gig sounds right

 

[Jakub W]

3Gig sounds right

Wow.. Ok thanks a lot. So far I had no luck finding one in online stores. Any hints on that?

 

[kingkorg]

Wow.. Ok thanks a lot. So far I had no luck finding one in online stores. Any hints on that?

Not really, but 1Gig is traditionally used there, i don't think it would make much difference if you used 1Gig.