stelin

Happy New Year!
« on: December 29, 2018, 06:32:21 PM »
Happy new year, all microphone builders!

Thank you Banzai, Rainton, RuudNL, Thiersch and everyone else who made my microphone builds possible!
This year I’ve built three M49 copies and two ribbon mics. Could not have done it without the support from GroupDIY!

- Stefan



Re: Happy New Year!
« Reply #1 on: December 31, 2018, 05:38:50 AM »
Happy new year to you too!  :D

Beautiful collection!!

Moby

Re: Happy New Year!
« Reply #2 on: December 31, 2018, 06:46:51 AM »
Happy New Year and happy mic building  :)
For microphone transformers,  BV.8,  Bv.11,  Bv.12, etc.. contact me at mobyelectronics at gmail dot com

Murdock

Re: Happy New Year!
« Reply #3 on: December 31, 2018, 07:08:01 AM »
Happy New Year!
Nice Mics!

We should make a dedicated thread were everyone, at the end of a year, post their stuff that they finished over that year  ;D

ln76d

Re: Happy New Year!
« Reply #4 on: December 31, 2018, 03:05:54 PM »
Happy new year!

RuudNL

Re: Happy New Year!
« Reply #5 on: December 31, 2018, 04:11:49 PM »
Happy New Year from The Netherlands for all microphone builders and audio lovers!
There is a solution for every problem!

http://www.vansteenisaudio.nl

Re: Happy New Year!
« Reply #6 on: December 31, 2018, 08:15:02 PM »
Happy New Year!

alexc

Re: Happy New Year!
« Reply #7 on: December 31, 2018, 10:58:16 PM »
And from way down here  :)  Happy New Year to all.

May we all further our diy horizons another year!

(Nice mics too)
I ping therefore I am

weiss

Re: Happy New Year!
« Reply #8 on: January 01, 2019, 11:23:36 AM »
Happy New Year from Germany  :)

Ansgar Scheffold
www.ansgarscheffold.com

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
937 Views
Last post December 15, 2009, 05:06:55 PM
by owel
18 Replies
1850 Views
Last post January 04, 2011, 04:14:09 PM
by Stagefright13
Happy new year

Started by detonator Brewery

13 Replies
1277 Views
Last post January 01, 2012, 10:35:26 PM
by pucho812
4 Replies
711 Views
Last post January 01, 2013, 08:26:45 AM
by Dr_J