Ba6a interstage

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
If you have an original then it should just go in, but if you want to check the calibration, then I would do it like this:-

A VU meter is designed to read O VU when in series with a 3.6k resistor, when 1.228V rms is across them both. You would need something like a signal generator with a 600 ohm output and set at say 400Hz. You can measure the voltage with a half decent DVM, there is no need to get picky about it, 1.23V would be fine. For more details read https://en.wikipedia.org/wiki/VU_meter
best
DaveP
Thanx heaps Dave i will pass that info on to my tech much appreciated Mike
 

Latest posts

Back
Top