Compact desktop line mixer?

[OneRoomStudio]

>> Here is what your LED-bargraphs look like "BEFORE" and "AFTER" by having one of the slots enlarged by 0.040" or 0.020" on each side of the LED-bargraph itself. On the left is how you currently have things fitting together by using a small hammer to force the LED-bargraph into the panel-slot. On the right, this shows a 0.020" tolerance gap all around the LED-bargraph, allowing it to easily fit through the slot and end up becoming flush with the top of the panel. For reference.....0.020" is about the standard thickness of 3 sheets of standard notebook paper pressed together, with each sheet being approximately 0.007" in thickness.

View attachment 145270

>> This image shows the LED-bargraph corner-edges and the tolerance gap clearance to the panel slot radii in each corner:
View attachment 145271

/

Thank you! I wouldn't have caught that. I'll update my file.

BTW, were you ever able to able to convert the enclosure to a 3D STL? I'd love to mess around with trying to figure out how I could fit things on the backplane PCB, so if you could share that, I'd really appreciate it.

 

[MidnightArrakis]

Thank you! I wouldn't have caught that. I'll update my file.

BTW, were you ever able to able to convert the enclosure to a 3D STL? I'd love to mess around with trying to figure out how I could fit things on the backplane PCB, so if you could share that, I'd really appreciate it.

[were you ever able to able to convert the enclosure to a 3D STL?] -- As a single enclosure file? Or.....as individual pieces???.....

/

 

[rh001]

Rather bizarre post tbh. There is still a choice of standard desktop mixers. The original question was about dedicated line input mixers. The reason lies in the evolution of audio tech.
Not bizarrely due to "population growth".
fwiw Population growth may be required to support an increasingly older non-wealth creating demographic.

It's ok to disagree but it's also ok to be polite. Why not just pretend you're Japanese. They say national hero and figure skating champ Yuzuru Hanyu is exceedingly polite...it works for him. Age: 30yrs Estimated networth $30 to $50 million.

 

[OneRoomStudio]

[were you ever able to able to convert the enclosure to a 3D STL?] -- As a single enclosure file? Or.....as individual pieces???.....

/

Ideally, as an explodable/ungroupable group of pieces (not sure if either of those are words).