boji
Well-known member
In FPE, it looks like you can increase the thickness of an engraved line by switching from a .4mm engraving bit to a 1.0mm cutter bit.
Have any of you experienced the end product when doing this? I want to confirm that the depth is not an issue when using the cutting bit. Also curious if swapping bits out is more expensive than extra passes using one type of bit throughout the engraving process?
Thanks!
Have any of you experienced the end product when doing this? I want to confirm that the depth is not an issue when using the cutting bit. Also curious if swapping bits out is more expensive than extra passes using one type of bit throughout the engraving process?
Thanks!