G
Guest
Guest
I have got a load of Calrec/Lundahl 5606 transformers
I now announce me total ignorance in trying to figure out what each pin does and what are the windings.
Lundahl say they don't have the datasheets because they were a custom for Calrec
They are chunky (like the 5402s) - I boguth them from a guy who works at Calrec
And have I think (from memory - I am not at home now)... 6 or 8 pins on one side and 5 or 7 pins on the other (ie one less pin on one side - and it's not in the middle - the pins line up each from side to side apart from one near the middle)
I do know that they were used for...
"in the module i pulled this from the transformer was stepping the output onf an ne5532 opamp down to 600 ohms.i'll look for further info"
Ok - I have a multimeter and persistance - what do I do
I now announce me total ignorance in trying to figure out what each pin does and what are the windings.
Lundahl say they don't have the datasheets because they were a custom for Calrec
They are chunky (like the 5402s) - I boguth them from a guy who works at Calrec
And have I think (from memory - I am not at home now)... 6 or 8 pins on one side and 5 or 7 pins on the other (ie one less pin on one side - and it's not in the middle - the pins line up each from side to side apart from one near the middle)
I do know that they were used for...
"in the module i pulled this from the transformer was stepping the output onf an ne5532 opamp down to 600 ohms.i'll look for further info"
Ok - I have a multimeter and persistance - what do I do