Helsing
Well-known member
I want to make a bent metal cap to put over a PC mount toroid transformer. It is inside a mic pre enclosure that just doesnt have room for a shield wall. The noise is very minimal but I would like to improve it.
I was thinking that I could put some flexible adhesive between the top of the transformerand the inside of the cap to hold it in place. The current draw is very low and the thing barely gets warm at all.
Does this shield/cap need to be grounded? Any other things I should know?
Helsing
I was thinking that I could put some flexible adhesive between the top of the transformerand the inside of the cap to hold it in place. The current draw is very low and the thing barely gets warm at all.
Does this shield/cap need to be grounded? Any other things I should know?
Helsing