pucho812
Well-known member
It's baaaaacccccccccccck.
O.k. you guys may or may not remember a thread I started a good while ago
http://www.groupdiy.com/index.php?topic=19965&highlight=tube+414
well I finally was able to procure the mic into the shop again , this time the conditions are as long as I need it as it is not in use at the moment.
So back to making a schematic and board artwork.:twisted:
So far the mic itself has the standard 414 capsule
it's attached to a 5840 submini tube(A Dave Royer fave). there are 2 resistors and a cap in circuit and that's in. The mic transformer is in the PSU. and it all comes out to a 6 pin connector. Shouldn't take long at all to get that drawn. Then the Psu is simple.
At any rate this makes a perfect candidate to use with maybe a ck12 from peluso or maybe a china mic.
O.k. you guys may or may not remember a thread I started a good while ago
http://www.groupdiy.com/index.php?topic=19965&highlight=tube+414
well I finally was able to procure the mic into the shop again , this time the conditions are as long as I need it as it is not in use at the moment.
So back to making a schematic and board artwork.:twisted:
So far the mic itself has the standard 414 capsule
it's attached to a 5840 submini tube(A Dave Royer fave). there are 2 resistors and a cap in circuit and that's in. The mic transformer is in the PSU. and it all comes out to a 6 pin connector. Shouldn't take long at all to get that drawn. Then the Psu is simple.
At any rate this makes a perfect candidate to use with maybe a ck12 from peluso or maybe a china mic.