tube 414 revisited

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
pucho812 said:
Cathode has got to go somewhere, to ground if nothing else... But then the bias doesn't make sense... Hmm...

Martin

you guys are good. Talk about missing something.  :oops:  After a third glance. I  saw it. Because things were so cramped inside  it was hard for me to see what  was connected and where. You can see that  in the original photos. So I updated the schematic of the mic portion. The cathode goes out to pin2 on the 6 pin XLR

here is the updated schematic


royertube414mic-1.jpg

Looks like pin 2 to cathode resistor in the PS
pin 6 to pattern control
pin 5 heater +
pin 3 ground
pin 4 B+

The 1000meg looks like it is added for LD capsules there is an hint in the Royer SD mod writeup. The SD CF Royer writeup does not have this resistor
 
Back
Top