WTB neve marconi knobs for (2) ez1073 1U rack builds

[Romanp]

Classicapi want 12.75 per knob. Dang!
I want 6 blue, 6 burgundy and 6 grey.
I suppose I am downgrading to plastic instead of aluminium.

 

[desol]

If you think that's expensive, try contacting Neve. I did.

They wanted 27gbp each + shipping. At today's rates, in Canada(where i am), that 's $48 bucks a piece!

I was here 'years ago when people were pining over these knobs. I'd say that's a good price, not to mention the fact that it's pretty cool they're even available!

 

[Winetree]

Just make sure that the shafts on the pots are long enough.
I couldn't use the CAPI knobs on the NV73 or 2254.

 

[TheJames]

Just make sure that the shafts on the pots are long enough.
I couldn't use the CAPI knobs on the NV73 or 2254.

Uhhh...Seriously?  I just ordered a pair for use on my NV73's.  That's a bummer.

 

[simonsez]

Just make sure that the shafts on the pots are long enough.
I couldn't use the CAPI knobs on the NV73 or 2254.

Yes it can, with little effort....assumed that you're using PCB mount grayhill rotary switch,
omit this (see pic) or replace with "thinner" one :
What you call it in english?  :-[

 

[useme2305]

that's a nut.

 

[Winetree]

So if the shaft is to short,
you have to remove the nuts,
to make the knob fit.

 

[simonsez]

So if the shaft is to short,
you have to remove the nuts,
to make the knob fit.

hmmm....nut? ..ok

Yes, remove the nuts, or replace it with nut from potentiometer , and you're done....(I did)

 

[Romanp]

I went ahead and bought the knobs from classicapi.
So this thread is closed.