PhilipMarlowe
Well-known member
- Joined
- Nov 28, 2019
- Messages
- 98
Is there an acceptable tolerance between transformers? It’s based on the Lundahl 1527 and balances unbalanced direct outs to balanced direct outs of my mixer.
Unfortunately some channels seem to be way more phase accurate than others and transmit transients better. One channel in particular sounds superb while one has less output and less transient energy.
I already checked cabling and soldering of the PcB the trannies are soldered onto, but it doesnt seem to matter, which just leaves the actual differences inside the transformers.
Is this normal and to be expected from standard non-bespoke transformers?
Unfortunately some channels seem to be way more phase accurate than others and transmit transients better. One channel in particular sounds superb while one has less output and less transient energy.
I already checked cabling and soldering of the PcB the trannies are soldered onto, but it doesnt seem to matter, which just leaves the actual differences inside the transformers.
Is this normal and to be expected from standard non-bespoke transformers?