Aharon
Well-known member
As you know I'm new to the forum and I have decided on 3 projects SSL Comp,Calrec EQ and G9 Pre.
I'm doing one at a time but thinking ahead I was going over the Calrec PCB and some pads are too close for comfort if I try to make it myself.
I noticed that the SSL PCB was cleaned up and a few pads shaved down etc for more tolerance.
Would it be possible to do the same for the Calrec and if yes how do I go about it?What's the best way?.
Thanks in advance
Aharon
I'm doing one at a time but thinking ahead I was going over the Calrec PCB and some pads are too close for comfort if I try to make it myself.
I noticed that the SSL PCB was cleaned up and a few pads shaved down etc for more tolerance.
Would it be possible to do the same for the Calrec and if yes how do I go about it?What's the best way?.
Thanks in advance
Aharon