MrG
Well-known member
Hey all,
I almost completed this entire build about 10 years ago, and am finally wanting to finish, and I’m running into confusion and lack of understanding with regards to how to measure and connect the 5 “legs” of the power supply. My situation is specifically:
-pre PCB is built according to K&K schemo
-PSU PCB is built, using a Hammond 269JX, an NTE5326 rectifier, and a large black circular capacitor that says something like jV 500V, -10% +30%, and 0 -20M.
-My question is what voltages and which leads should be connected to the Mic Pre PCB from the PSU?
I’ll be attaching the PSU docs here as soon as I can but I’m not at my desktop. Please let me know if and what I can further provide to help clarify this.
Best,
MG
I almost completed this entire build about 10 years ago, and am finally wanting to finish, and I’m running into confusion and lack of understanding with regards to how to measure and connect the 5 “legs” of the power supply. My situation is specifically:
-pre PCB is built according to K&K schemo
-PSU PCB is built, using a Hammond 269JX, an NTE5326 rectifier, and a large black circular capacitor that says something like jV 500V, -10% +30%, and 0 -20M.
-My question is what voltages and which leads should be connected to the Mic Pre PCB from the PSU?
I’ll be attaching the PSU docs here as soon as I can but I’m not at my desktop. Please let me know if and what I can further provide to help clarify this.
Best,
MG