niccolo
Member
Hi,
i begin this post with a big THANK YOU to all the nice people of this board, i'm learning a lot here simply lurking and reading the endless Meta-threads.
My probably silly question is this:
Looking at some DIY project's BOM's, Gyraf's ones in particular (Jakob, you rule!), i've noticed that resistor's tolerances are often 1%, then looking at Farnell, Mouser etc. i see that there exist tolerances as low as 0.001%.
Is there any noticeable performance gain in using tolerances lower than specified in the project?
Thanks a lot again
niccolo' gallio
i begin this post with a big THANK YOU to all the nice people of this board, i'm learning a lot here simply lurking and reading the endless Meta-threads.
My probably silly question is this:
Looking at some DIY project's BOM's, Gyraf's ones in particular (Jakob, you rule!), i've noticed that resistor's tolerances are often 1%, then looking at Farnell, Mouser etc. i see that there exist tolerances as low as 0.001%.
Is there any noticeable performance gain in using tolerances lower than specified in the project?
Thanks a lot again
niccolo' gallio