GssL 20th Anniversary edition

[janczmok]

Don't be confused. I'll explain:
- BOMs and Reichelt Part Lists should be updated by now.
- the referenced Corrections "Rev 3 needs following..." need to be applied. It's in the blend Circuit as outlined, and the wrong part is in Side chain HP switch.
Let me know if i can assist you..

 

[Gustav]

I'm still a bit confused about the errata

The errate under this header is not relevant to the rev 3 board.

Errata to make the test run board perfect

Its just left there to the handful of people who are building the test board...

...and none of it will make a difference between a unit just blowing up or not. If it did, it wouldve been posted in bold and repeated 20 times.

Gustav

 

[inf0]

@Gustav Are you aware of any other switches that could directly work on the switch pcbs? I was thinking of maybe using some grayhills and wire them.

There is something about the feel of the lorlins that I really don't enjoy

 

[Gustav]

@Gustav Are you aware of any other switches that could directly work on the switch pcbs?

Sorry, I dont know of a switch that shares the exact footprint.

I also happen to think the Lorlins are great for most applications - including this one Of course, you can wire up anything you like, how you like, which is the great thing about DIY.


Gustav

 

[Andado]

So this will do it for Threshold, Gain, Blend, Colour trim?

 

[janczmok]

Speaking of Wiring:
As i am using NRG illuminated Push Switch (like SSL Solid State Logic) - i found need 560 Ohm for the LED switch. There is no dedicated LED Resistor (or connector) somewhere on the PCB, correct ? Guess i can wire it to Pos12V and Resistor on the PCB.

Is there a definitive wiring guide ? As i see the pads like "Bypass in" (just as an example) and the associated X101-4 ( i assume )
If not i can try to start with one and get corrected when i am wrong ?!?