shabtek
Well-known member
boards arrived, look nice
thanks JMan!
thanks JMan!
Awesome, I’ll double check the size and give them a whirl! Thanks guys!Those are MIL spec resistors...high quality! Check out the spec sheet linked below. I also like them because the values are actually printed on the body. The inexpensive 1% ones with the color stripes are usually difficult to read; "Is that a brown, red, or orange stripe? Which end of the resistor is the beginning when the value starts with 1/brown since the tolerance is also a brown stripe?" Yes...my eyeballs have excellent color acuity. It's the crummy paint used in manufacturing.
https://www.vishay.com/doc?31027
Bri
Noted. Yes, should be 22nF (.022uF). I will update the BOM this afternoon when I am at home. Thank you for that catch!Going through the posted Mouser BOM (only for the components I do not already have so not a complete list) and I have found a discrepancy.
The part listed for C3,7, & 23 is a .22uF, it should be .022uF. I found MKS2-.022/63/5t to work
Going through the posted Mouser BOM (only for the components I do not already have so not a complete list) and I have found a discrepancy.
The part listed for C3,7, & 23 is a .22uF, it should be .022uF. I found MKS2-.022/63/5t to work
Good point, I don’t think of that.You can consider a shaft adapter like that, but you'll still need to be sure that the nut is large enough to secure on the hole on the front panel. That would be my primary concern. I do not know the answer to this. I believe the 1/8" switch has a smaller bushing which might present a problem, but maybe not?
Enter your email address to join: