It's sounds great, They are matched well and then I tested with white-noise in stereo at different Q values, the low-end was the only Q that was a little different, and I'm sure it was a pot variance.
I put the 33u's in as show in the PDF, I put the top on and racked it this morning, I can draw but I visually checked the top board. (hard to do upside down). The PDF was what I used to verify, because that you can use 300%+ zoom in and see a piece of the + in the picture, on the circuit board you got a viarable place on the drill hole and sometimes you could see the + and sometimes not on the board.
I don't think I saw any conflicts, that would have prompted a post.
I'll unrack it again and re-re-verify, don't suppose that could account for the gain variance?
is anyone getting a db gain when the eq is engaged at a flat response curve?